Custom Machined Plastic Parts

With our machining capabilities, we are able to make a wide assortment of plastic parts.

We use Swiss screw machines, auto Hardinge and computer controlled Hardinge. Epoxy, Delrin®, Nylon®, Teflon, Phenolic and G-10 are just a few examples of the materials we run. Little or no tooling charges applied, with low minimum quantities and a quick turn around time.
  • From prototype to production
  • We can work from prints, sketch and samples
  • Spacers, Bushings Standoffs, Washers
  • Slotted, Drilled, or Leaded
  • Any round part with an OD up to 1.00” x 2.00” long
Important Notice:

All statements, information and data given on our website are believed to be accurate and reliable but are presented without guarantee or warranty or responsibility of any kind, expressed or implied. Further, these are furnished upon the condition that users of our products must make their own tests to determine suitability of each product for their particular purposes. Data shown within this website is not to be used for specification purposes.  Statements or suggestions concerning possible use of our products are made (1) without any representation of patent immunity and (2) with reservation of all patent rights.